Offer > Accessories & programs


Accessories & programs

Software:

P1200Configuration software for meters of P1200 series, v1.28 (400kB)

T1200Configuration software for transmitters of T1200 series manufactured before 07.2017, v2.30 (430kB)

NOTE: new communication protocol has been implemented in T1200 transmitters manufactured since 07.2017. Therefore, for their configuration newer software is required (v 3.0 or higher, see below).

T1200Configuration software for transmitters of T1200 series, v3.02 (370kB)

T1500Configuration software for transmitters of T1500 series, v1.05 (330kB)

T1580Configuration software for trip relays of T1580 series, v1.04 (320kB)

All programs, besides programmable modules configuration, allow simulation and live observation of chosen module's performance. Additionally, outputs may be driven independently from inputs, module's performance may be displayed on time-dependent diagram and stored in csv standard accepted by spreadsheet programs. To observe module's on-site performance one should use adapters, connecting a module with computer, equipped in galvanic isolation.



Adapter T1201, T1501


Adapter T1201, T1501

Main purpose of the T1201 (T1501) adapter is to make possible configuration of programmable modules of T1200 (T1500) series - and that without a need of separate power supply. The cable interface, of about 1 meter length, ends with 9-pin DB9 connector on one side and a Jack plug (T1201) or mini-USB connector (T1501) on the other.



Adapter T1205, T1505


Adapter T1205, T1505


Main purpose of the T1205 (T1505) adapter is to make possible configuration of programmable modules of T1200 (T1500) series - and that without a need of separate power supply.The cable interface, of about 1 meter length, ends with USB connector on one side and a Jack plug (T1205) or mini-USB connector (T1505) on the other.



Adapter T1206, T1506


Adapter T1206, T1506


Main purpose of the T1206 (T1506) adapter is to make possible configuration of programmable modules of T1200 (T1500) series - and that without a need of separate power supply.The cable interface, of about 1 meter length, ends with USB connector on one side and a Jack plug (T1206) or mini-USB connector (T1506) on the other. Thanks to the galvanic isolation adapter may be used also for on-site configuration or observation of programmable module's performance without a risk of electrical shock or of forming ground loops.




Top of pageTop of page        BackBack
Copyright © 1999- by CCIBA®